johnny said be careful but.... Sorry to admit that I pinched the programming cable installing a BBS02 kit on my 08 Specalized Crosstrail. Is it possible to splice this or do I need to buy a new motor? This is the cable that comes out of the motor, before the harness plug. Don't want to make it more broken
top of page
bottom of page
I found some controllers on Amazon. Can't find any 52v 750w, There is a 52v 1000w. Will this work?
I’d get a new controller unless you are an experienced wire-worker 👍
Worst case you would need to replace the controller for about $120. You shouldn't have to replace the entire motor.
Yeah, too bad, you'll have to buy a new motor.
BTW, I'll take that piece of junk off your hands, even pay for the shipping.
Just kidding!
Depending on where you pinched the cable, it may be a little tricky. ie if it's close to the motor case, but there aren't that many wires and they are all coloured differently. They would have to be soldered and carefully insulated but it shouldn't be difficult to fix.